WebIO7 Temperature Monitor Software
WebIO7 Temperature Monitor software for graphing temperature sensors and providing advanced automation and SSL email.
WebIO-TM is a software application that runs on a PC Computer running the Microsoft Windows Operating system.
This application provides for advanced configuration of WebIO7
wireless temperature and humidity sensor for monitor and control automation.
Wireless sensor events are received from a WebIO7 installed on a local or remote network.
WebIO-TM provides secure (SSL) email/SMS/text message notification based on wireless sensor temperature readings.
*NEW* WebIO-TM v2.00 supports WebIO7. This app was originally created for WebIO v3.
This app contains the same features of the WebIO7 Service Tool application for locating WebIO7 units on your local network. No need to also install the Service Tool app.
WebIO7 Temperature Monitor app - Sensor readings screen
WebIO7-TM v2.01 software download
WebIO7-TM 2.01 is available as a zip file containing an application file.
unzip this file to a location on your PC where the application will have write access to its log files.
There is no install program for v2.01 at this time.
Also provide feedback on this app, as its very new to WebIO7 with room for many improvements.
Download: WebIO7-TM_v201.zip
WebIO7-TM Graphing
Up to five wireless temperature sensors can be selected for graphing (20+ sensors can be logged). The graph to the right displays the 12 hours of monitoring wireless temperature sensors used in the solar thermal panel system. Measurements include: Solar Thermal Panel temperature, Solar heating duct, Garage (outside temperature) and Heating boiler.
A Solar Thermal Heating Panel Project
See also: Information on WebIO v3 used to automate a solar thermal heating panel. Solar thermal heating project
WebIO7-TM Temperature Graph
WebIO7-TM Automation
WebIO7-TM can perform X10 power line, wireless AC outlet and relay control automation based on wireless temperature sensor readings. When WebIO7-TM receives a sensor reading from WebIO7, it can perform a list of control automations commands based on defined temperature thresholds for Low, In-Range and High. When a sensor reading meets a threshold, WebIO7-TM executes any defined control automations for the threshold by sending each control command back to WebIO7.
Control Automation Setup Screen
WebIO7-TM Email Notification
The WebIO7-TM software notification is in addition to the email notification already provided internally to WebIO7. In some cases the WebIO7 internal automation and notification configuration may not provided for a more complex set of automation rules. This app allows for more complex automation rules and for connection/use of secure email services such as gmail. WebIO7 internal email only supports SMTP email with no SSL.
The Notification Page allows you to set the Normal range for each temperature sensor. When temperature goes below or above the defined range an Email or SMS text message will be sent to the defined “Send Notification Email” address.
More information on WebIO-TM can be found in the WebIO v3 documentation: WebIO v3 documentation Since there is no WebIO7-TM documentation at this time.
More information on WebIO7-TM Email setup: WebIO7-TM Email
Email notification automation Setup Screen