WebIO7 Temperature Monitor Software

WebIO7 Temperature Monitor software for graphing temperature sensors and providing advanced automation and SSL email.

WebIO-TM is a software application that runs on a PC Computer running the Microsoft Windows Operating system. This application provides for advanced configuration of WebIO7 wireless temperature and humidity sensor for monitor and control automation. Wireless sensor events are received from a WebIO7 installed on a local or remote network. WebIO-TM provides secure (SSL) email/SMS/text message notification based on wireless sensor temperature readings.
*NEW* WebIO-TM v2.00 supports WebIO7. This app was originally created for WebIO v3.

This app contains the same features of the WebIO7 Service Tool application for locating WebIO7 units on your local network. No need to also install the Service Tool app.


WebIO7 Temperature Monitor app - Sensor readings screen

WebIO7-TM v2.01 software download

WebIO7-TM 2.01 is available as a zip file containing an application file. unzip this file to a location on your PC where the application will have write access to its log files. There is no install program for v2.01 at this time. Also provide feedback on this app, as its very new to WebIO7 with room for many improvements.

Download: WebIO7-TM_v201.zip

WebIO7-TM Email - Verify WebIO7 Connection

Quick, screenshots showing WebIO-TM setup for Email on Temperature. Start with verify connection to WebIO7.


WebIO7-TM Email Setup

Setup a email account for WebIO-TM to use as a client to send emails. The screenshot demonstrates using a gmail account. Remember to click [save].


WebIO7-TM Temperature Sensor setup

Enter each Wireless sensor you want to log, graph and email on temperature out-of-range. Enter ID of sensor as found on WebIO7 temperature web page. Also give the sensor a Name. Sensor Data will now begin to show up on Sensor Data page. Sensors update about every 1.5 minutes.


Above: WebIO-TM sensor setup, below: WebIO7 Temperature Sensor webpage showing source of Sensor ID

WebIO7-TM Notification (send email)

Enter each a Min and Max value for each Temperature sensor you would like notification on. When Temperature is outside of range (max) then an email is sent if additional rules are met. For each sensor select additional rules, Enable, Notify once per state change, and/or Require 2 consecutive out of range readings. Also note the "Global" Notification check box in upper right corner. Enter the Email addres to which emails will be sent to, via email in Email Setup page. use [Send Test Email] to verify email setup is correct. Select [Save] button.


WebIO7-TM Temperature Data

Temperature data is refreshed, highlighting last sensor received from.


WebIO7-TM Events

Events are logged in the Events page, including emails, errors and WebIO7 boot events.